This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
howto [2008/01/23 07:08] 76.100.119.159 |
howto [2010/05/18 13:06] twdorris |
||
---|---|---|---|
Line 8: | Line 8: | ||
* [[NitrousControlWiring|Basic "nitrous" controls]] - The basics of wiring up a solenoid to be control by DSMLink's "nitrous" controls | * [[NitrousControlWiring|Basic "nitrous" controls]] - The basics of wiring up a solenoid to be control by DSMLink's "nitrous" controls | ||
* [[NitrousControlDetails|"Nitrous" control specifics]] - More specific information about DSMLink's control of the FPR solenoid output | * [[NitrousControlDetails|"Nitrous" control specifics]] - More specific information about DSMLink's control of the FPR solenoid output | ||
- | * [[UseNitrousControlsForDejonToolBOVMod]] | + | * [[UseNitrousControlsForDejonToolBOVMod|"Nitrous" control used for BOV bypass mod]] - Describes one alternative use of DSMLink's "nitrous" controls |
* [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | * [[InstallNewSensor|Install a sensor for datalogging]] - Describes how to use a non-factory sensor for datalogging (e.g., a boost sensor, a wideband kit, etc.) | ||
+ | |||
===== Tuning/dial-in ===== | ===== Tuning/dial-in ===== | ||
- | * [[MAFTCalibrationByWBO2]] | + | * [[BasicFuelAdj|Changing injectors]] - Describes how to adjust DSMLink for different injectors |
- | * [[MAFTCalibrationByLoggedBoost]] | + | * [[v3mafadjcombft|General MAF calibration]] - How-to on general MAF calibration with the V3 application |
- | * [[CreateVolumetricEfficiencyMap]] | + | * [[MAFTCalibrationByWBO2|MAFT Calibration using a WBO2]] - Describes how to calibrate a MAFT output using a WBO2 |
- | * [[2GTimingIn1GECU]] | + | * [[MAFTCalibrationByLoggedBoost|MAFT Calibration using a boost sensor]] - Describes how to calibrate a MAFT output using a boost sensor |
- | * [[DSMLinkTPSAdjustment]] | + | * [[CreateVolumetricEfficiencyMap|Customize the VE table for your setup]] - Create a VE table more suited to your specific setup |
+ | * [[v3tpsadj|How to dial in TPS/idle switch]] | ||
- | ===== Alternate OS'es ===== | ||
- | * LinuxInstall | ||
- | * MacOSInstall | ||
- | * PocketPCInstall | ||